#SPATIAL.ascii 1

// This database is used to specify the boundary conditions for the
// dislocation (kinematic fault) example.

// This follows the format for a Simple DB (the only type presently available).
SimpleDB {

  // There are 3 values specified in the database, corresponding to the
  // constraint values for the x, y, and z degrees of freedom.
  num-values = 3
  value-names =  dof-0 dof-1 dof-2

  // The constraint values (displacements) have units of meters.
  value-units =  m  m  m

  // The values are specified at two spatial locations.
  num-locs = 2

  // The dimension of the spatial distribution is 1, since the data
  // is being specified at points.
  data-dim = 1

  // The spatial dimension of the database is 3.
  space-dim = 3

  // We are specifying the data in a Cartesian coordinate system.
  cs-data = cartesian {

    // Our units are already in meters, so we can just multiply by one.
    to-meters = 1.0

    // We are using a 3D Cartesian coordinate system.
    space-dim = 3
  }
}

// This is where the data is specified.
// As described in dislocation.cfg, this database will be used to specify
// data along faces (pylith.bc.BCSixSides).
// The entries are:
// X-coord, Y-coord, Z-coord, dof-0, dof-1, dof-2.
-1.0  0.0  0.0     0.0  0.0  0.0
 1.0  0.0  0.0     0.0  0.0  0.0