% **** US Robotics 56K ERROR CORRECTING MODEM CONFIGURATION FILE **** % % first value following the 'start of data' line is the max online time % the next value is the timeout (both values are seconds) % ********************************************************************* % edit why % 95/11/28 x0 permits connection at speeds other than tmon knows % 97/10/03 created USR 56K configuration % # start of data 3600 60 % set the re-initialization cycle time to be sufficiently often % to guarantee access within that time. default is 300 seconds. TCMDCYCLE=300 % attempt several times to get modem's attention, but require no % command echo. the command delay is in milliseconds, default 2000. TCMDDELAY=40 TCMDNOECHO AT AT AT % initialize modem, wait 1 sec to stabilize. sometimes no OK follows, % so don't wait for it. TCMDDELAY=1000 % reset using factory default 2 parameter set for software flow control % this sets &D2 &B1 &H2 ATZ5 % now require echoes on further commands, and process them quickly TCMDECHO % switch off automatic baud rate adjustment TCMDNOADJUST % note: the cmd delay must be 150 minimum, so the delay is doubled TCMDDELAY=300 % disable auto answer on first ring % disable +++ % ignores dial tone and busy. sends plain connect result % disable protocol result codes % XON/XOFF sent to modem and remote system % modem ignores RTS % reset (and hang up) on DTR drop; non MNP connection uses 128b buffer % run in "software compatibility" mode, always showing 9600 connect speed % enable "fail safe" 250 minute on timer % extend carrier drop % enable auto answer on first ring ATS0=0 S2=255 X0 &A0 &I1 &R1 S13=3 S27=136 S19=250 S10=20 S0=1